Professional Maintenance Tips for Heating and Cooling System |
Posted: April 9, 2020 |
Heating and cooling systems are not too complicated when it comes to maintenance. Regular maintenance of your air conditioner will reduce money spent on you Air Conditioner repair and enhance efficient operation. There are various types of heating and cooling units but regardless of the type used, there are some tips required to keep the system in good condition. Primary Tools and Materials Needed for Maintenance First of all, you will need some tools like pliers, screwdriver, flashlight, brushes, vacuum cleaner, newspaper, rags and so on. Some materials like fan belt dressing, refractory cement, motor oil, and duct tape would be required. Most of these materials can be gotten from hardware stores. Causes of Some Heating and Cooling System Breakdown When heating or cooling systems break down, it could be caused by either the thermostat, heat/cold source, or distribution system. Also, if the air conditioner fails to run, the problem could be from the source. Probably, the furnace may have lost its power. Or fuel may not be flowing down to the unit. It could also be that fuel, whether gas or oil is not igniting. If the air conditioner or furnace is switched on and its cool or warm air is not circulating the whole rooms, then the distribution system or blower may be faulty. A bad thermostat can prevent the system from operating smoothly (either stops it from turning on or make it consistently switch from on to off). Whatever the condition, you can begin with the easiest process for maintenance. In any case, you find yourself, it takes common sense and patience to resolve it. Before you or your technician begin any work on your heating and cooling system, there are some vital steps to take: Make sure nothing is breaking the power. Check for tripped circuit breakers at the main panel or blown fuses. There are furnaces with different power entrances; so take note of this. It is usually located at the panel close to the main entrance. Others have their fuses installed on the unit or inside it. There should be a reset button on the unit close to the motor housing. However, after locating the reset button wait for 30 minutes for the motor to calm before hitting the button. If any delay is noticed, wait for an extra 30 minutes before hitting the button again. You can try it once more if it fails to start. If there is a separate power control on the unit, make sure it is turned on. Set the thermostat carefully. If necessary, increase the setting 5 degrees or lower it if it's an air conditioner. If the system makes use of gas, switch it on and also make sure the pilot light is turned on. If it makes use of oil, confirm that the oil is enough and there is a constant supply. Conclusion In summary, taking care of your heating and cooling system is easy but in some cases may be complicated. Ensure to reach a professional technician to take care of it for you if you don't know much about it. Always apply safety measures when dealing with your HVAC system.
|
||||||||||||||||||||||||||||||||||||||||||
|